Ф4 ФицЖу,
Asfrsmbly schedule:
I. Fi»teti 2 ektej ix? mid frorne.
Align frame with marks ar the sick? panel».
2, Assemble
be lai end stern tr.oraoms,
3, I ratal L all
ether bulkheads ffromeaj
4. Assemble etiixh the heel side,
Icosely
5,
Unfold
3a,
bottom by laying the two sides tn top of aach other,
the batterri
ever ord Install a-,'er the hull sides end ргсгпед,
Flip It
Chert: frame lines align cm ent end bull symetry before
the	taping.
7. Tlahtcn dll stltrhe» erd flip ths hull. <7vwrJ
-9. Solid ердху fl licit» and topee see -epony аеати- drouibau
Assembly sequence
Sail Options

II? 1/4.’
Hola far
atap gives
IMS vtf
Eqw scot bulkhead
r Aa-seea hole
4^ cleat
Meet etsp hole for eprlt rfg is olianrd with partner hole, 3" forward of mast bulkhead. Center af merconl meet is 3—1/2“ forward! this T raha at mast top-
Extra FG tape and re air putty. Drain optional. Scotian;
3/S“ ply
Rudder pintle® Wilcox #4«J-3/+ Rudder audgeons WHooa #443+—3/4 Upper gudgeon is installed Г1 lower
Mast step made of 3/4" predrilled for mast, badded In raeln puttyr covered with FG tape.
plywood,
trenearri

ahsot horea
3/ЕГ ply
3/eT ply
Stitch and Glue procedure
Laminate with 1708 biaxial fiberglass tape 5” widek
Grind outside, fill gap with putty. Grind or remove copper wire, Laminate with 6”’ tape, second layer optional,
Lamiration schedule:
Chine, bow, transom inside: biaxial 1708, 6* wide, one layer Keel, in and outside:
Biaxial 1708. & wide. one layer Outside all, seats, and frames: 9 oz. tape, 6* wide
Rudder, tiller and daggerboard constr uction
У-4’
at 1/3
u taper to 1
* а/а'
— а а/а1
□ 1/4’
? fsz*
Q)4 ФыгдЛыр,
Typical rudder and and centerboard section max. width
<4

Rudder & Daggerboard from 3/4?l ply epoxy coaled
5 f?
4 5/6"
ul
— з w
3 3/4’
fill sheets included in large scale plans...
Daggerboard trunk:
<'D4 Ditiglui
L cut sides from 1/4” ply
2,
l'-l Э/&'
5,	cut f slot through bottom
6.	install trunk box in hull
7.	install two half forward bulkhead
8,	tape bottom and sides with FG tape and putty fillet
б* from outside, round edges of slot and coat with epoxy.
assemble cleats and spacers as shown
coat 2 halves with epoxy
assemble two halves, use cleats Г' wide
Cut fwd seat bulkkhead from 3/8” plywood
1/4 ply
FQ tope
Daggerboard case assemblg